ESP32-H2 - Zigbee End Point - 2 gang switch

Jean-ChristopheP
Posts: 1
Joined: Fri Nov 29, 2024 3:00 pm

ESP32-H2 - Zigbee End Point - 2 gang switch

Postby Jean-ChristopheP » Fri Nov 29, 2024 3:02 pm

Hi,

I'm quite new in ESP world. Good general IT knowledge, but not a developer (more infra guy).

The goal is to program an ESP32-H2 as a 2 gang toggle switch.

I had a look at the examples in the ESP-IDF and the Arduino IDE documentation but I can't find what I'm looking for.

What I find so far is button coordinator or light end point. I need a button end point.

I find a post explaining that I "just" need to invert the initialization part of both code to end up with button end point. I tried that in Arduino IDE and it compiles without error. The "problem" now is that when I link my new device in HomeAssistant, it doesn't populate the button. Only the device's status. I must be close to a solution but I'm stuck.

I don't mind going back to ESP-IDF if I can get help.

Does anyone of you have an idea how I could achieve this ? In my mind, it should be too complicated but I lack the needed skills.

Thanks in advance.

Who is online

Users browsing this forum: No registered users and 41 guests