Cant Detect/Flash ESP32-S2 WROOM

[VaultBoy]

Hi i am currently new to this whole genre of technology im currently getting into ps4 jailbreaking and decided to buy a ESP32 S2 Development Board For PS4 9.0 Refresh USB Burning Tool Module 4MB Flash off of ebay. i just have 2 questions and i'd be the happiest man in the world.

A. How to put this into Flash mode considering its just one button
B. What drivers do i need for my computer to even dectect this which is not although the light is on and i've tried other usb ports

the specifications are:
ESP32-S2-WROOM is general-purpose Wi-Fi MCU module with PCB board-mounted antenna, powerful function and rich peripheral interface, which can be used in wearable electronic devices, smart home and other scenes.
MCU:
Built-in ESP32-S2 chip, Xtensa® single-core 32-bit LX7 microprocessor, supports up to 240 MHz clock frequency.
128 KB ROM
320 KB SRAM
16 KB RTC SRAM
Wi-Fi:
802.11 b/g/n
Data rates up to 150 Mbps
Frame aggregation (TX/RX A-MPDU, RX A-MSDU)
0.4 µs guard interval
Operating channel center frequency range: 2412 ~ 2484 MHz
Hardware:
Module Interfaces: GPIO, SPI, LCD Interface, UART, I2C, I2S, Camera Interface, IR, Pulse Counter, LED PWM, USB 1.1 OTG, ADC, DAC, Touch Sensor, Temperature Sensor
40 MHz integrated crystal
4 MB SPI flash
Operating/Power Voltage: 3.0 ~ 3.6 V
Recommended Operating Temperature Range: -40 ~ 85 °C
Dimension: 68mm*18mm

Here is also the link to the EBAY POST
https://www.ebay.com/itm/315261297526

[liaifat85]

I believe you'll find all of your answers here: https://docs.espressif.com/projects/esp ... t-started/

[lbernstone]

Hold the button down while you plug it into the computer.