I am trying to make temperature sensors work on ESP32S3 + ESP32-C6.
The sensor is a TUYA Zigbee
The manufacturer gives some information here.
After binding the sensor to my network, I am telling it to occasionally report with this command:
Code: Select all
esp_zb_zcl_config_report_cmd_t report_cmd;
uint8_t report_change = 5;
report_cmd.zcl_basic_cmd.dst_addr_u.addr_short = ((zdo_info_user_ctx_t *)user_ctx)->short_addr;
report_cmd.zcl_basic_cmd.dst_endpoint = ((zdo_info_user_ctx_t *)user_ctx)->endpoint;
report_cmd.zcl_basic_cmd.src_endpoint = HA_THERMOMETER_ENDPOINT;
report_cmd.address_mode = ESP_ZB_APS_ADDR_MODE_16_ENDP_PRESENT;
report_cmd.clusterID = ESP_ZB_ZCL_CLUSTER_ID_TEMP_MEASUREMENT;
esp_zb_zcl_config_report_record_t records[] = {
{ESP_ZB_ZCL_CMD_DIRECTION_TO_CLI, ESP_ZB_ZCL_ATTR_TEMP_MEASUREMENT_VALUE_ID, ESP_ZB_ZCL_ATTR_TYPE_S16, 10, 20, &report_change}};
report_cmd.record_number = sizeof(records) / sizeof(esp_zb_zcl_config_report_record_t);
report_cmd.record_field = records;
esp_zb_zcl_config_report_cmd_req(&report_cmd);
Report change = 5.
Minimum update interval = 10
Maximum update Interval = 15.
The sensor ignores all of this.
Im getting irregular reports, every 100 to 300 seconds or so.
- Screenshot 2023-12-01 at 3.27.48 pm.png (251.64 KiB) Viewed 3973 times