is stub and send flash finish

[ABEARIA]

I'm getting it to upload to my 1MB ESP-01, but my ESP-01 won't create a network... Any solutions? The SPI speed is 40MHz and the SPI mode is QIO. Should it say "is stub and send flash finish" when it is finished uploading?

Using the ESPRESSIF Flash Download Tools V3.9.5

https://www.espressif.com/en/support/do ... ther-tools


Here is my log:

*************************** START ****************************
START TIME: 202307201549
CONNECT BAUD: 115200
set state: ESP_DL_SYNC
serial port opened
-----------
baud:115200
root baud:115200
-------------
===============BAUD : 115200===============CALL DEVICE SYNC
connecting...
0x3ff00050: 7dd00000
0x3ff00054: 02005f4c
0x3ff00058: c200b000
0x3ff0005c: 00483fda
check_err_0: 0bcheck_err_1: 00check_err_2: 00check_err_3: 02check_err_4: 0b====================
EFUSE NORMAL MODE
====================
=========================
CRC IN MODE 1:
crc_calc_res: 194
target crc val: 194
=========================
=========================
CRC IN MODE 1:
crc_calc_res: 208
target crc val: 208
=========================
==================
EFUSE LOG:
======================

EFUSE LOG:

---------------

REG0:7DD00000

REG1:02005F4C

REG2:c200b000

REG3:00483FDA

----------------

====================

EFUSE NORMAL MODE

====================
EFUSE CHECK PASS...48bit mac
-----------------------
48 3f da 5f 4c 7dCUSTOM_ID: 0C 20 00 00 00 0D 00 00
MAC AP : 4A-3F-DA-5F-4C-7D
MAC STA: 48-3F-DA-5F-4C-7D
get mac res: 1
get flash id : 0x00144068
manufacturer_id: 0x68
device_id: 0x4014

Wrote 3856 bytes at 0x00000000 in 0.3 seconds (effective 97.1 kbit/s)...
Hash of data verified.
Wrote 330756 bytes at 0x00001000 in 21.2 seconds (effective 124.6 kbit/s)...
Hash of data verified.
Wrote 344708 bytes at 0x00081000 in 22.1 seconds (effective 125.0 kbit/s)...
Hash of data verified.
Wrote 128 bytes at 0x000fc000 in 0.0 seconds (effective 23.1 kbit/s)...
Hash of data verified.
Wrote 4096 bytes at 0x000fe000 in 0.1 seconds (effective 418.0 kbit/s)...
Hash of data verified.
Leaving...
com closed
Use time: 45 s
Download result: PASS
*************************** END ****************************

[ESP_Sprite]

What does the serial monitor say when trying to run the program?