(POWERON_RESET) after power on the esp

[nstylianou]

Hi all,

I'm having a problem with the ESP-WROOM-32 .
The problem is that when I power the ESP it gives the following message.
<<" ets Jun 8 2016 00:22:57

rst:0x1 (POWERON_RESET),boot:0x21 (DOWNLOAD_BOOT(UART0/UART1/SDIO_FEI_REO_V2))
waiting for download ">>
however Esp is fool functional ,and the circuit to boot works perfectly.

I upload program via Arduino IDE with board->ESP32 Wrover Module.

does anyone know how my ESP after power on stop boot and start its program normally??

[ESP_Sprite]

Is there something connected to GPIO0 of the ESP? If this is pulled low, the chip will go into download mode.

[corz.org]

WROVER != WROOM.

Switch board definitions.

As for boot-up, it sounds like you are also pressing the IO0 button (boot) instead of just reset/rst. Press only ONE button, unless you are trying to upload (which you shouldn't need to press any buttons for, if your setup is working correctly).