I work with esp32 and esp-prog jtag debugger on Visual Studio Code (1.64.0) and esp-idf (v1.3.0) for a few months without big problema ... but at the enad of dicember i no be able to go in debug mode with esp-prog, i was checked all pin on board and debugger, checked driver on windows (with zadig) and at the and i was install all on other pc, but the comunication not not works ...
I'm desperate enough to accept any suggestions
follow the comuniucation log
tahks in advance
Code: Select all
Open On-Chip Debugger v0.10.0-esp32-20210401 (2021-04-01-15:46)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 2
adapter speed: 20000 kHz
Info : Listening on port 6666 for tcl connections
Info : Listening on port 4444 for telnet connections
❌ Error: libusb_open() failed with LIBUSB_ERROR_NOT_SUPPORTED
Info : ftdi: if you experience problems at higher adapter clocks, try the command "ftdi_tdo_sample_edge falling"
Info : clock speed 20000 kHz
Info : JTAG tap: esp32.cpu0 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : JTAG tap: esp32.cpu1 tap/device found: 0x120034e5 (mfg: 0x272 (Tensilica), part: 0x2003, ver: 0x1)
Info : esp32.cpu0: Debug controller was reset.
Info : esp32.cpu0: Core was reset.
Info : esp32.cpu1: Debug controller was reset.
Info : esp32.cpu1: Core was reset.
Info : Listening on port 3333 for gdb connections
Info : accepting 'tcl' connection on tcp/6666
Info : dropped 'tcl' connection