Achieving Low Power while using the WiFi

[papaisou11]

Hello,

Help Needed. I am starting to design a circuit that is a door lock system. However, It will be battery Powered and I am expecting it to last 1 Year at least using a 3.7V 2500mAH battery. My problem is, if it is continuously connected to the wifi 24x7, it will not last long due to the Power consumption of ESP32. I could not make it sleep as someone will send door unlock or lock command it needs to be received by it.

I am expecting 10-15 lock-unlock events entire day. How can I reduce the current consumption of ESP32? This is the most power hungry system in my application. For all other devices, such as motor, sensors, all will be disconnected from power source until or unless I receive the command from wifi.

[WiFive]

Most of the locks on the market use plug in wifi bridges. The eufy lock that uses wifi has a 10Ah battery to last 12 months.

[alanesq]

This thread may be of interest
https://www.esp32.com/viewtopic.php?t=12067

[boarchuz]

I had another look at this today out of interest, as there have been significant improvements to light sleep since my comment in the linked thread - average ESP32 light sleep current now settles <400uA with the right config.

With a very high listen interval of 30 (ie. max ~3 seconds between receiving queued up packets from the router), I'm seeing about 850-1100uA average current now with WiFi connected. That's pretty good, but you're still going to chew through your battery in less than half the target time, and that's without the motor, sensors, interface, etc.

There's a TCP task waking the ESP32 every 500ms though, which isn't helping. Might be a bug? Giving this task a much higher timeout, and setting the listen interval to 50, average current can go as low as 600uA while maintaining a WiFi connection.

ESP32-WROOM-32D, ebf7e811b12e3c1e347340e5b9ec014e9c6319ba