ah, thanks john.johnlee wrote:about the supply voltage range. the main issue is not with ESP32, but with the flash chips which usually runs off 3.3V, with the exception of some vendors which went as low as 2.2V. with ESP32, we decided to try using 1.8V flash; hence we can now go to 2.0V.
can you say about i2c too. is this a mistake ( 3x i2c ) - have we 2xi2c like datasheet?
how are you? hope you are fine.
you make yourself scarce here. I know you prefer to twitter.
this is also a lot easier.
you know, if you can create RSS FEED here on a forum thread?
Then the news on twitter are currently here in a thread.
it is possible
how to
would be nice if we had a eMbedded timeline on top of the forum.
so we are on timeline here too
best wishes
rudi