With a jumper between GPIO13 and GND, running your example code, I don't see any wakeup happening.
Which development board are you using?
DEEPSLEEP_RESET
Re: DEEPSLEEP_RESET
It is perhaps the way I do it that is wrong. I have attached the wire to GND already and then with the other end connect to GPIO13 it then trigger a wake up. It must be EMI when wire touches GPIO and a pull down resistor would perhaps filter out this
Thanks
Thanks
Re: DEEPSLEEP_RESET
Hi
It still does not work with this simple setup.
I have changed the wake up stub to be delayed with 500 ms as suggested in this thread.
I have a AC adapter (5 volts) that goes into a 3.3 voltage regulator and the output (3.3 volt) is wired to GPIO13 directly.
I would then expect GPIO13 to be set high when I plug the AC adapter to power and trigger the wakeup and it does - sometimes.
If I repeat this process there is no pattern for when wakeup is triggered.
Why would that be?
Thanks for keeping up with all my questions
It still does not work with this simple setup.
I have changed the wake up stub to be delayed with 500 ms as suggested in this thread.
I have a AC adapter (5 volts) that goes into a 3.3 voltage regulator and the output (3.3 volt) is wired to GPIO13 directly.
I would then expect GPIO13 to be set high when I plug the AC adapter to power and trigger the wakeup and it does - sometimes.
If I repeat this process there is no pattern for when wakeup is triggered.
Why would that be?
Thanks for keeping up with all my questions
Who is online
Users browsing this forum: Bing [Bot], Google [Bot], Jblight32 and 109 guests