wrover kit shematic V2 "SD Card"

[rudi ;-)]

hi guys

after several times doing sd card things i have a time to look up on the shematic detailed and see,
that DATA2 is not pulled up ( NC )

Wrover_sd_Card.png (81.11 KiB) Viewed 5678 times

i wounder me, is this cause GPIO12 or do we not need to pull up this line.
i remind to me, that ivan talked, we must pulled up all lines ( hope have understand well )
can you do a small state to this please?

thank you
best wishes
rudi

[ESP_Angus]

Hi Rudi,

IO12 is not pulled up on the board because it needs to be low on reset to enable 3.3V flash voltage. Refer to this note in the sd_card example README:
https://github.com/espressif/esp-idf/bl ... out-gpio12

I found that on my ESP-WROVER-KIT boards, the sd_card example worked without any software or hardware modifications. However you may get different behaviour with a different SD card.

If your card is still not working, check you have connected the SD_IO2 to IO2 jumper as described on page 8 of the ESP-WROVER-KIT getting started guide PDF: http://espressif.com/en/support/download/documents

[rudi ;-)]

hi Angus

txs for fast reply
I thought this into thoughts, cause gpio12, but was not sure.

yes can confirm, here sd card example works without modifikation on wrover.

thank you!

best wishes
rudi