Hi all,
I'm trying test the smartconfig feature on my WROOM module via esp-at version:2.1.0.0 SDK version:v4.0-327:
AT+CWMODE=1
AT+CWSTARTSMART
however ESPTOUCH on my IPhone7 IOS 13.5.1 (both v1 "app v2.0.0 sdk v0.3.7.0" and v2 "app v2.0.0 sdk v0.9.4") does not seems to work and keep showing an empty "EspProvision" page.
Anyone is having the same issue ?
Is there a better solution than ESPTOUCH using esp-at for wifi credentials provisioning ?
Best Regards
Giampaolo
esp-at and smartconfig (ESPTOUCH)
Re: esp-at and smartconfig (ESPTOUCH)
Hi all,
could it be that ESPTOUCH works only in IEEE 802.11 aka "legacy" mode ?
https://github.com/espressif/esp-idf/issues/5243
am I the only one having this problem ?
tnx,
Giampaolo
could it be that ESPTOUCH works only in IEEE 802.11 aka "legacy" mode ?
https://github.com/espressif/esp-idf/issues/5243
am I the only one having this problem ?
tnx,
Giampaolo
Re: esp-at and smartconfig (ESPTOUCH)
problem solved... ESPTOUCH works as expected...
the problems were on my IOS network settings.
the problems were on my IOS network settings.
-
- Posts: 16
- Joined: Tue Feb 09, 2021 10:45 pm
Re: esp-at and smartconfig (ESPTOUCH)
@iw2sli
I am in the same boat as you were, my ESP32 will not see the ESPTOUCH app request.
Can you give me some help??
I am in the same boat as you were, my ESP32 will not see the ESPTOUCH app request.
Can you give me some help??
-
- Posts: 16
- Joined: Tue Feb 09, 2021 10:45 pm
Re: esp-at and smartconfig (ESPTOUCH)
This is what happens to me:
AT+CWMODE=1
OK
AT+CWSTARTSMART=1
OK
AT+CWSTARTSMART
ERROR
=
I don't know what to do once I issue the AT+CWSTARTSMART command.
What kind of a loop do I go in?
Why does it throw an ERROR?
AT+CWMODE=1
OK
AT+CWSTARTSMART=1
OK
AT+CWSTARTSMART
ERROR
=
I don't know what to do once I issue the AT+CWSTARTSMART command.
What kind of a loop do I go in?
Why does it throw an ERROR?
-
- Posts: 16
- Joined: Tue Feb 09, 2021 10:45 pm
Re: esp-at and smartconfig (ESPTOUCH)
I fixed the error, but I don't know how to go into a loop for the RS232/AT command version and wait for the smartconfig on the ESP32 to reply back to me.
after I set AT+CWSTARTSMART it says OK but there is no further replies about the status of the negotation, etc.
how to handle this in a loop while waiting for RS232 replies from the ESP32?
after I set AT+CWSTARTSMART it says OK but there is no further replies about the status of the negotation, etc.
how to handle this in a loop while waiting for RS232 replies from the ESP32?
Who is online
Users browsing this forum: No registered users and 274 guests