Recommendations for a PCB designer

[scalhoun]

Hey everyone, new poster here.

I've been working on a low-power liquid measuring device using the esp32 and a water-proof ultrasonic sensor on and off for about a year now. Up until this point I've been using the firebeetle for testing but I think I'm too the point that I'm ready to hire someone to help further develop and design a custom board for the project.

As a new member, I cannot direct message so this has been a little challenging on this forum since I started the search by referring to older similar posts.

I did see some recommendations for @loboris but I have been unable to contact due to my restrictions on the forum.

Any recommendations for someone who could help would be greatly appreciated!

[scalhoun]

I did get a pm but I am unable to reply. How many posts are required on this forum before I can use the messaging system?

Screenshot 2019-01-21 11.04.00.png (19.81 KiB) Viewed 3907 times

[ESP_Sprite]

I think it's 3 or 5 or so, but I'll make your life a bit easier and get that limit off of you.

[scalhoun]

Thank you, it is much appreciated!