There is a error When ESP32 use IIS with UART in a project

[LeoXie]

Hello Everyone,


There is a error When ESP32 use IIS with UART in a project, If I don’t use IIS. The all of UART working is fine, and then, I enable the IIS with UART1 at same time, the follow error is occurred, By the way, the program can be running, but UART not working.

QQ截图20190109172624.png (109.12 KiB) Viewed 4282 times

If I enable IIS with all of UART, the program always restart, and I catch the log in below. Register IIS interrupt error that 0x105 was returned.

IIs error.png (113.72 KiB) Viewed 4282 times

This picture shows The IDF version

IDF version.png (53.62 KiB) Viewed 4282 times

Thanks a lot.
Best Regards,
Leo,

[ESP_@In逍遥子]

Could you please run the app using IDF Monitor ("make monitor" or "idf.py monitor") tool? This will produce a readable backtrace.
See monitor.

The resulting backtrace will give more information to figure out what the issue is.

[LeoXie]

I am sorry for repley delay.


I was set wrong, I correct it, It's work.