ESP-WROVER-KIT LCD Code does not run!!!

[ats3788]

Hello ESP32 Community

Can someone tell me why this code does not run

Code: Select all

#include "SPI.h"
#include "Adafruit_GFX.h"
#include "WROVER_KIT_LCD.h"

#define min(X, Y) (((X) < (Y)) ? (X) : (Y))

WROVER_KIT_LCD tft;

void setup() {
  Serial.begin(115200);
 
  tft.begin();
  tft.setRotation(1);

  uint8_t x = 0;
  uint32_t id = tft.readId();
  if(id){
      Serial.println("======= ILI9341 ST7789V Display Test ========");
  } else {
      Serial.println("======= ILI9341 ILI9341 Display Test ========");
  }
  Serial.println("============================================");
  Serial.printf("Display ID:      0x%06X\n", id);

  x = tft.readcommand8(WROVER_RDDST);
  Serial.print("Status:          0x"); Serial.println(x, HEX);
  x = tft.readcommand8(WROVER_RDDPM);
  Serial.print("Power Mode:      0x"); Serial.println(x, HEX);
  x = tft.readcommand8(WROVER_RDDMADCTL);
  Serial.print("MADCTL Mode:     0x"); Serial.println(x, HEX);
  x = tft.readcommand8(WROVER_RDDCOLMOD);
  Serial.print("Pixel Format:    0x"); Serial.println(x, HEX);
  x = tft.readcommand8(WROVER_RDDIM);
  Serial.print("Image Format:    0x"); Serial.println(x, HEX);
  x = tft.readcommand8(WROVER_RDDSDR);
  Serial.print("Self Diagnostic: 0x"); Serial.println(x, HEX);
  
 
  Serial.println(F("Done!"));
  tft.fillScreen(ILI9341_ALICEBLUE);
  tft.setTextColor(ILI9341_BLUEVIOLET);

}

void loop(void) {
	tft.print("*");
    delay(1000);
}

That is all what I get

• Opening port
  Port open
  read err, 1000
  ets_main.c 371
  ets Jun 8 2016 00:22:57
  
  rst:0x10 (RTCWDT_RTC_RESET),boot:0x3e (SPI_FAST_FLASH_BOOT)
  configsip: 0, SPIWP:0xee
  clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
  mode:DIO, clock div:1
  load:0x3fff0018,len:4
  load:0x3fff001c,len:952
  load:0x40078000,len:6084
  load:0x40080000,len:7936
  entry 0x40080310

Power Supply just the USB

[ESP_Sprite]

Moved to Arduino subforum.