ESP32-WROVER temperature specification change

[lipigl]

Also waiting for feedback

[ESP_Sprite]

We are still tesing some Wrover modules this week. Seems everything takes a while because we need to collect samples from multiple lots, to be sure a pass isn't just due some edge case that the lot we test is just on the right side of. I'll post any results here when testing is done.

[WiFive]

ESP32-WROVER Datasheet
2018.11 V2.0 Updated the recommended operating temperature from –40 °C ~ 65 °C to –40 °C ~ 85 °C.
Updated Chapter 6: Schematics, where C18 is changed from a 1 µF capacitor to a 4.7 µF capacitor

Clarification? Are these two changes related? Meaning will modules without increased bulk capacitance on the 1.8v rail perform adequately at high temps? What about WROVER-B?