Wakeup mode

[MuchMore]

I would need to the chip to wakeup on LOW on three seperat pins.
Defining three esp_sleep_enable_ext0_wakeup does not work.
And using a Bitmask and esp_sleep_enable_ext1_wakeup only gives me two options:

Code: Select all

typedef enum {
    ESP_EXT1_WAKEUP_ALL_LOW = 0,    //!< Wake the chip when all selected GPIOs go low
    ESP_EXT1_WAKEUP_ANY_HIGH = 1    //!< Wake the chip when any of the selected GPIOs go high
} esp_sleep_ext1_wakeup_mode_t;

I would need "ESP_EXT1_WAKEUP_ANY_LOW".
Is this technical not possible or was this just omitted??

[Haldi4803]

3 Years later i have the exact same question.

My Buttons are default HIGH and i want to wake up the device if any of the 3 Buttons is pressed.
Using Pin 34, 35 and 39.
There is no way to inverse the pins in Deep Sleep is there?

[Archibald]

Consider inverting electronically. The CD4049 CMOS integrated circuit has maximum quiescent current of 1μA, typically 0.02μA.