Console Baud Rate

[jerrybarber]

I set the 'UART Console Buad Rate' to a different value (57600) in menuconfig. But when the device boots (ESP-WROOM-32) it still prints a lot of output at 115200.

Only after it gets to app_main is the output sent at 57600.

Is there any way to get the initial bootup output to happen at 57600?

Also, is there a way suppress to this initial bootup output?

Thanks.

[WiFive]

Pull MTDO low to disable rom boot logging.

[jerrybarber]

Thanks, works great.