3D Printer control
-
paulbearne
- Posts: 3
- Joined: Fri Jul 07, 2017 5:29 am
3D Printer control
Hi i've just finished laying up a pcb to control my D-bot 3d printer based on my existing rumba board.http://esp32robots.co.uk/index.php/hard ... controller the gerbers and schematics are also on my site. and was wondering if any body has looked at porting marlin or repetier or done any firmware work for a 3d printer that i might be able to modify for my set up.
Who is online
Users browsing this forum: No registered users and 320 guests