ESP32-U4WDH 'No serial data received'

[Vitaly]

When power is supplied, there is no message in the monitor.
After a hardware reset, there is no message in the monitor.
No response to TX
Power supply: 3.3v/0.6a
Adapter: CP2102
I bought 25 chips, assembled 3 identical devices - all three are silent.
I can't figure out what I'm doing wrong.
Sketches attached
[/attachment]

20250121_224941.jpg (112.75 KiB) Viewed 2502 times

1737487704140.jpg (89.59 KiB) Viewed 2502 times

troub-U4.jpg (340.12 KiB) Viewed 2498 times

[ESP_Sprite]

I strongly suggest you go over the esp32 hardware design guidelines and see if your schematics match that. For instance, it says:

External Crystal Clock Source (Compulsory)

The ESP32 firmware only supports 40 MHz crystal.

and that is just one of a bunch of things I see you not doing in your schematic.

[Vitaly]

So, in the absence of an external crystal 40MHz, it is impossible to read the chip ID? The internal 8 MHz generator does not support the serial port?

[Vitaly]

So, thanks for the consultation, I am satisfied