hi all,
I installed the espressif-idf 5.2 on windows.
I included the ide too.
If I use command line tools it's works fine. I can switch to my board (idf.py set-target esp32s3) build and flash it.
But on the ide I didn't have the board option for s3.
I have only 4 options (esp32 - esp32c2 -esp32c3 - esp32h2). If I try to add a new launch target, in ESP target i have the same options, and no esp32s3.
Someone have a solution?
thanks
Sandro
esp32s3 not selectable in espressif ide
Re: esp32s3 not selectable in espressif ide
Are you facing the same problem that is shown here?
https://github.com/espressif/idf-installer/issues/231
https://github.com/espressif/idf-installer/issues/231
Re: esp32s3 not selectable in espressif ide
Yes! It Is.
I will try this solution.
Thanks
Sandro
I will try this solution.
Thanks
Sandro
Who is online
Users browsing this forum: No registered users and 274 guests