- ESP-ROM:esp32s3-20210327
- Build:Mar 27 2021
- rst:0x1 (POWERON),boot:0x8 (SPI_FAST_FLASH_BOOT)
- SPIWP:0xee
- mode:DIO, clock div:2
- load:0x3fce3808,len:0x3ac
- load:0x403c9700,len:0x9b4
- load:0x403cc700,len:0x2908
- SHA-256 comparison failed:
- Calculated: c0cf91409b6e8a9ebb3be9aa4bc24145a18278e6c7411fcfc5fd4816f574b49b
- Expected: ccbdf521f90ffa902a0f72b4d1bdaa90e077361003a1c152131c93a62b8a7c0e
- Attempting to boot anyway...
- entry 0x403c98bc
- E (233) esp_core_dump_flash: No core dump partition found!
- E (233) esp_core_dump_flash: No core dump partition found!
- Configure access piont
- [ 273][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 0 - WIFI_READ
- Y
- [ 316][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 10 - AP_START
- [ 321][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 11 - AP_STOP
- AP-IP Address192.168.4.1
- [ 1064][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 10 - AP_START
- #include <Arduino.h>
- #include <WiFi.h>
- const char *ssid = "ESP32";
- const char *password = "PASSWORD";
- void setup() {
- Serial.begin(115200);
- Serial.println("Configure access piont");
- WiFi.softAP(ssid, password);
- IPAddress myIP = WiFi.softAPIP();
- Serial.print("AP-IP Address");
- Serial.println(myIP);
- }
- void loop() {
- }
Code appears to run fine based on serial prints, but the AP never shows up for either my Windows or Ubuntu laptops. Same code on the dev kit shows up just fine.