ESP32 virtual network interface

[pmoneta]

Hello, i would like to know if there is a way to point to esp32 netif ethernet interface (like "en1" or "ETH_DEF") while using an HAL library from software that runs on linux. I already figured out how to port the storage HAL, filesystem HAL and threads HAL, and i'm currently trying to port the ethernet HAL, with no success.

The library show the following line to choose a virtual network interface using NIC names:

esp32.jpg (22.94 KiB) Viewed 2050 times

I've tried every possible combination from esp_netif ("/dev/net/en1", "en1", "eth0", "eth", "ETH_DEF", etc) and couldn't get it to work, and i have already configured the ethernet interface and obtained these parameters (i'm using the WT32-ETH01 board):

esp322.jpg (9.74 KiB) Viewed 2050 times

So i was wondering if i'm really ABLE to point that interface in the first place, because esp uses freertos and i don't know if i can use these NIC names on this operating system.

[ESP_Sprite]

This probably doesn't work as any Linux calls on that interface don't have an equivalent in LwIP (the TCP/IP stack ESP-IDF uses). Possibly you need to track down those calls and change them to their ESP-IDF equivalents.

[pmoneta]

So i should point to the ethernet driver and not netif? I didnt find any esp32 interface in the programming guide

[pmoneta]

Thanks! i figured out that i have to create my own HAL for esp32!

[andreaslundeen]

I am also interrested in this setup. Can you share some of your progress?

[pmoneta]

I am also interrested in this setup. Can you share some of your progress?

sry for the late response. what do you want to know?