SD card esp wrover kit v3 with esp wroom 32 revision 0

[SoubaK]

Hi,

I have an ESP Wrover Kit v3 with an esp32 wroom revision 0. On this board there is no SD_IO2 pin, but when I try to get the sd card example from esp-idf I get an error saying that I have to connect pull up resistor to the SD

E (975) sdmmc_req: handle_idle_state_events unhandled: 00000004 00000000
E (975) sdmmc_cmd: sdmmc_card_init: send_op_cond (1) returned 0x107
E (985) example: Failed to initialize the card (263). Make sure SD card lines have pull-up resistors in place.

How can I use sd card on this board?

Thanks
SoubaK