ESP-12F (ESP8266) interrupt for RC-Switch library 433Mhz signal
Posted: Wed Oct 16, 2024 8:30 am
Hello friends
I want to modify this Arduino code for esp8266 – ESP-12F.
(It's RC-Switch Sample)
My question is about this line equal in ESP
mySwitch.enableReceive(0); // Receiver on interrupt 0 => that is pin #2
I try code by "D2" and connect module to pin D4.
it's work but built blue LED always show fast pulse.
I'm not sure but I think it's not stable because it's need to define interrupt and some code.
I want stable code for use interrupt to read RF433/315Mhz module in loop by ESP-12F as same as Arduino code.
Thanks
I want to modify this Arduino code for esp8266 – ESP-12F.
(It's RC-Switch Sample)
My question is about this line equal in ESP
mySwitch.enableReceive(0); // Receiver on interrupt 0 => that is pin #2
I try code by "D2" and connect module to pin D4.
it's work but built blue LED always show fast pulse.
I'm not sure but I think it's not stable because it's need to define interrupt and some code.
I want stable code for use interrupt to read RF433/315Mhz module in loop by ESP-12F as same as Arduino code.
Thanks
Code: Select all
#include <RCSwitch.h>
RCSwitch mySwitch = RCSwitch();
void setup() {
Serial.begin(9600);
mySwitch.enableReceive(0); // Receiver on interrupt 0 => that is pin
}
void loop() {
if (mySwitch.available()) {
output(mySwitch.getReceivedValue(), mySwitch.getReceivedBitlength(), mySwitch.getReceivedDelay(), mySwitch.getReceivedRawdata(),mySwitch.getReceivedProtocol());
mySwitch.resetAvailable();
Serial.println();
}
}