ESP32 S3 wroom 1 board on ESP Rainmkaer

[Trupal]

Hello team ,


Can I use ESP RainMaker on ESP32 S3 wroom 1 board? because when I try to upload GPIO example it shown following errors.

Error log :-
I (103182) esp_claim: Starting the Self Claim Process. This may take time.
E (110122) esp_claim: Invalid response for https://esp-claiming.rainmaker.espressi ... aim/verify
E (110122) esp_claim: Status = 400, Data = {"status":"failure","description":"Invalid challenge response"}
E (110132) esp_claim: Claim Verify Failed.

above errors are not shown on other ESP32 boards (Like, ESP32 S3 wroom 2 and wroom 1u as well).


Thank you
Trupal

[ESP_Piyush]

This can happen only if the board is too old and does not have the secret programmed in the efuse. Can you run this command

Code: Select all

espefuse.py summary --port $ESPPORT

and share the output over email at esp-rainmaker-admin@espressif.com. Please do not share this information here on the forum.

[Trupal]

This can happen only if the board is too old and does not have the secret programmed in the efuse. Can you run this command

Code: Select all

espefuse.py summary --port $ESPPORT

and share the output over email at esp-rainmaker-admin@espressif.com. Please do not share this information here on the forum.

Okay ,Thank you for the information. I will send the detail as soon as possible.

[Trupal]

This can happen only if the board is too old and does not have the secret programmed in the efuse. Can you run this command

Code: Select all

espefuse.py summary --port $ESPPORT

and share the output over email at esp-rainmaker-admin@espressif.com. Please do not share this information here on the forum.

I have sent the output in mentioned mail. Hope you find well.

Can you please check it ?

Thank you
Trupal