Recommendations for a PCB designer
Posted: Thu Jan 17, 2019 3:10 pm
Hey everyone, new poster here.
I've been working on a low-power liquid measuring device using the esp32 and a water-proof ultrasonic sensor on and off for about a year now. Up until this point I've been using the firebeetle for testing but I think I'm too the point that I'm ready to hire someone to help further develop and design a custom board for the project.
As a new member, I cannot direct message so this has been a little challenging on this forum since I started the search by referring to older similar posts.
I did see some recommendations for @loboris but I have been unable to contact due to my restrictions on the forum.
Any recommendations for someone who could help would be greatly appreciated!
I've been working on a low-power liquid measuring device using the esp32 and a water-proof ultrasonic sensor on and off for about a year now. Up until this point I've been using the firebeetle for testing but I think I'm too the point that I'm ready to hire someone to help further develop and design a custom board for the project.
As a new member, I cannot direct message so this has been a little challenging on this forum since I started the search by referring to older similar posts.
I did see some recommendations for @loboris but I have been unable to contact due to my restrictions on the forum.
Any recommendations for someone who could help would be greatly appreciated!