Boot GPIO issue
Posted: Tue Jan 15, 2019 7:19 am
Hi everyone,
Am using gpio 0 as push button and it is normally connected to full up when pressed it should read as low, but when i use small code for testing purpose it is working properly and when i use big code which has 4 tasks and around 7000 line code and this time gpio 0 is reading always low only and some other gpio's also using but those are working fine but gpio 0 does't. Any suggestions can be appreciated.
Thanks
Am using gpio 0 as push button and it is normally connected to full up when pressed it should read as low, but when i use small code for testing purpose it is working properly and when i use big code which has 4 tasks and around 7000 line code and this time gpio 0 is reading always low only and some other gpio's also using but those are working fine but gpio 0 does't. Any suggestions can be appreciated.
Thanks