No lights and no response after uploading blynk
Posted: Fri Dec 16, 2016 4:39 am
I put the arduino core for esp 32 on arduino IDE and uploaded Blynk for wifi onto my ESP32 and it turned off the 2 leds on the board.
The arduino serial monitor shows it connecting to Blynk server and sending lots of info, but Blynk app shows ESP 32 is not in network.
So I can't control esp32 and it doesn't light up but chip does make a bit of heat like it is working.
I can reupload the Blynk for ESP 32 and it still does nothing with the leds, no flashes nothing, even when hitting reset.
What should I do from here?
I have never had problems with my 8266 or Wemos D1 so don't know what I'm doing wrong with this.
The arduino serial monitor shows it connecting to Blynk server and sending lots of info, but Blynk app shows ESP 32 is not in network.
So I can't control esp32 and it doesn't light up but chip does make a bit of heat like it is working.
I can reupload the Blynk for ESP 32 and it still does nothing with the leds, no flashes nothing, even when hitting reset.
What should I do from here?
I have never had problems with my 8266 or Wemos D1 so don't know what I'm doing wrong with this.