Sync pin problems on the MCPWM module
Posted: Sat Jun 09, 2018 5:29 pm
Is there a way to set MCPWM timers to reset on only rising edge/falling edge/LOW/HIGH incoming signal. I couldn't find a way on the esp read the docs as well as on manual.
Currently my timer get reset on both rising and falling edge of the incoming signal. I want to reset it only when the signal is LOW or it is either of rising or falling edge.
[img]
[/img]
Currently my timer get reset on both rising and falling edge of the incoming signal. I want to reset it only when the signal is LOW or it is either of rising or falling edge.
[img]
- InterruptError.jpeg (144.68 KiB) Viewed 4059 times