BLE , Transmitting Service UUID in GAP mode
Posted: Sun Apr 15, 2018 1:12 pm
Hi all , I am learning the BLE . I have currently implemented the GAP mode in ESP-32 .
I would like to state that everything is running fine , but there are problems while advertising the Service Data in the Advertising packet . THe problem is that my peripheral device ( ESP-32 ) is visible in the app but Services by the device are not visible
Below is the my Code & I am using the NRF Connect app for observing the Service UUID & Service Data . If anyone could be point me out in the right direction ( for what I am doing wrong ) , I am open to any suggestino related to Concept of BLE , GAP or Debugging Tool I should be using ??
Code can be found in attachments ( sorry I didn't paste it , as it was not formatted properly )
Thank You
I would like to state that everything is running fine , but there are problems while advertising the Service Data in the Advertising packet . THe problem is that my peripheral device ( ESP-32 ) is visible in the app but Services by the device are not visible
Below is the my Code & I am using the NRF Connect app for observing the Service UUID & Service Data . If anyone could be point me out in the right direction ( for what I am doing wrong ) , I am open to any suggestino related to Concept of BLE , GAP or Debugging Tool I should be using ??
Code can be found in attachments ( sorry I didn't paste it , as it was not formatted properly )
Thank You