does anyone know how to run this component?
I mean, i can run it on P4, but there is problem on C6 side and i dont know if the firmware on C6 is correct one to work with esp-extconn on host.
I have such logs on C6:
Code: Select all
I (491) main_task: Calling app_main()
I (492) fg_mcu_slave: *********************************************************************
I (501) fg_mcu_slave: ESP-Hosted-MCU Slave FW version :: 0.0.6
I (511) fg_mcu_slave: Transport used :: SDIO only
I (520) fg_mcu_slave: *********************************************************************
I (529) fg_mcu_slave: Supported features are:
I (534) fg_mcu_slave: - WLAN over SDIO
I (538) h_bt: - BT/BLE
I (541) h_bt: - HCI Over SDIO
I (545) h_bt: - BLE only
I (549) fg_mcu_slave: capabilities: 0xd
I (553) fg_mcu_slave: Supported extended features are:
I (559) h_bt: - BT/BLE (extended)
I (563) fg_mcu_slave: extended capabilities: 0x0
I (578) h_bt: ESP Bluetooth MAC addr: 9c:9e:6e:5a:6d:16
I (579) BLE_INIT: Using main XTAL as clock source
I (584) BLE_INIT: ble controller commit:[7491a85]
I (585) BLE_INIT: Bluetooth MAC: 9c:9e:6e:5a:6d:16
I (591) phy_init: phy_version 310,dde1ba9,Jun 4 2024,16:38:11
W (638) phy_init: saving new calibration data because of checksum failure, mode(0)
I (656) phy: libbtbb version: 04952fd, Jun 4 2024, 16:38:26
I (657) SDIO_SLAVE: Using SDIO interface
I (658) SDIO_SLAVE: sdio_init: sending mode: SDIO_SLAVE_SEND_STREAM
I (663) SDIO_SLAVE: sdio_init: ESP32-C6 SDIO RxQ[20] timing[0]
E (1197) SDIO_SLAVE: sdio_rx_task: err: read_len[256] < len[256]+offset[1]
E (1197) SDIO_SLAVE: sdio_rx_task: err: read_len[256] < len[256]+offset[1]
E (1201) SDIO_SLAVE: sdio_rx_task: err: read_len[256] < len[256]+offset[1]