Page 1 of 1
ESP32 Hanging after flashing
Posted: Wed Nov 01, 2017 9:14 pm
by rwel59
Every couple of times that I flash new code, the esp32 hangs after printing this line to the monitor:
D (208) clk: RTC_SLOW_CLK calibration value: 3289318
I restart and everything is fine again.
Re: ESP32 Hanging after flashing
Posted: Thu Nov 02, 2017 6:21 am
by chegewara
Same here, and sometimes is just hanging in middle of flashing. Yes, i have good quality USB cable and there was no issue with esp-idf v2.1.
Re: ESP32 Hanging after flashing
Posted: Sat Nov 04, 2017 5:07 am
by kolban
Just to add my 2 cents. I too have started to see this symptom in a variety of random tests. As stated, a reboot and it starts right up again just fine.
Re: ESP32 Hanging after flashing
Posted: Sat Nov 04, 2017 7:51 am
by WiFive