question about remote peripheral
Posted: Mon Oct 30, 2017 1:21 pm
Hey all,
As far as I can tell, the only way to terminate a receive on the Remote peripheral is to set the idle threshold. Is there no way to terminate a receive after a specified number of period/level value pairs?
This requires that my idle threshold is longer than the longest expected period in the signal, which causes quite a bit of delay before the receive interrupt triggers.
Any thoughts or workarounds for this? Maybe I need to look into the capture units on the PWM peripheral.
As far as I can tell, the only way to terminate a receive on the Remote peripheral is to set the idle threshold. Is there no way to terminate a receive after a specified number of period/level value pairs?
This requires that my idle threshold is longer than the longest expected period in the signal, which causes quite a bit of delay before the receive interrupt triggers.
Any thoughts or workarounds for this? Maybe I need to look into the capture units on the PWM peripheral.