PC SW for EPS32-C3 module configuration with AT commands similar to u-blox modules "S-center" program.
Posted: Sun May 14, 2023 3:26 pm
Hello.
I ask if there is a PC SW for configuring the EPS32-C3 module using AT commands.
On the u-blox modules there is the PC SW to facilitate the programming of the module through the AT commands you can use the
"S-center" downloadable free of charge from the site https://www.u-blox.com/en/product/ s-center.
It is a very useful tool to facilitate module programming through AT commands.
Isn't there a similar program for the EPS32-C3 module ?
I await your kind reply.
BR
Demetrio Magrin
I ask if there is a PC SW for configuring the EPS32-C3 module using AT commands.
On the u-blox modules there is the PC SW to facilitate the programming of the module through the AT commands you can use the
"S-center" downloadable free of charge from the site https://www.u-blox.com/en/product/ s-center.
It is a very useful tool to facilitate module programming through AT commands.
Isn't there a similar program for the EPS32-C3 module ?
I await your kind reply.
BR
Demetrio Magrin