ESP32 Forum

( edit 18 Oct 2016 - Figure 1.1 updated )

esp32-devkitc_getting_started_guide_en.pdf
ESP32
ESP-WROOM-32

This user guide introduces the basic features and operations of the ESP32-DevKitC.
PDF
V1.1 ( Octobre 2016 )
Getting Started

https://espressif.com/en/content/esp32- ... rted-guide
direct: esp32-devkitc_getting_started_guide_en.pdf

please do allways visit espressif resource site for update and newer versions!


best wishes
rudi

source pic and note this link

Too bad it's not "breadboard friendly" aka requires 2 breadboards. Hope to have mine in a few days. Time to play!

WiFive wrote:Too bad it's not "breadboard friendly" aka requires 2 breadboards. Hope to have mine in a few days. Time to play!

no - take one breadboard, take the power supply in the middle between the breadboard lines -
then you have enough space.

Symbol Pic ( ESP32 )

this breadboard i took, this is not good to show the practice, but hope for understand.
there are breadboads with fixed pin lines and a space between, but there are breadboads you can "build your own design" any pluggable lines and can be combined like you need.

best wishes
rudi

ps: yes it is time to play - but why only one?
let me know if you have one - then we can start together
i wait for the developer in the picture too, think same in few days is it here.
just in time at custom office for clearing - the delivery station is only 2 hour from me - hope i get it at weekend.
then its playtime and rock time.

I think there is an error in the ESP32 DevKitC Getting Started Guide. If we look at the labels for the pins, they are labeled (in the document):

* 3V3
* EN
* SVP
* IO34

while on the actual board they are:

* 3V3
* EN
* SVP
* SVN
* IO34

I think its a simple mistake in the annotation of the diagram, but one that should likely be fixed.

Guys,
A second error in the getting started guide. Look at the label of the pin just north of the 5V line on the left. It is labeled "GND". It is not GND but actually CMD.

Fyi I poked our techwriters to look into releasing a corrected version.

...Which they have posted: http://www.espressif.com/sites/default/ ... ide_en.pdf

Rudi, would you mind modifying the image in your first post to the corrected one?

ESP_Sprite wrote:...Which they have posted: http://www.espressif.com/sites/default/ ... ide_en.pdf

Rudi, would you mind modifying the image in your first post to the corrected one?

yeap , done .