ESP32 Forum

Hii

I am using a custom board having esp32c3 chip which has internal flash . when i am working with normal gpio pins its working properly , my problem is that when i started working with wifi and Ble , i have flashed the code at that time its RESETTING CONTINUOUSLY.

could anyone help me with this problem.
helps are highlt appreciated

regards
srikanth

You need to be a bit more specific; we've been trying to hire clairvoyants who can simply divine problems from usernames but we have not had much success from it, sorry for that. What code did you flash? Any chance of bugs in there? What power supply do you use; are you sure it's enough to supply the ESP32C3 (>=500mA)? Any log messages on the crash?

no bugs are there while compiled,after the code flashed in the terminal it's resetting,by abort called (abort());and the terminal is continuosly refreshing .

the power supply is correct to the board.

Sorry, our search for clairvoyants still hasn't turned up anyone; HR is doing their best but it's a tough market. With that in mind, can you also answer the other questions I asked? Also, do you think that you could perhaps post the exact log that you're seeing? 'I see an abort message' is a bit imprecise. Also, how did you decide the power supply is 'correct'?