Page 1 of 1

Footprint

Posted: Fri Jul 22, 2016 10:37 am
by Graham1904
Although there is documentation around that shows the Gerbers for the PCB footprint if one is making up an new part, for say Eagle CAD, then the exact pad placements and dimensions are required.

Does anyone have this information to hand?

Re: Footprint

Posted: Fri Jul 22, 2016 1:58 pm
by rudi ;-)
Graham1904 wrote:Although there is documentation around that shows the Gerbers for the PCB footprint if one is making up an new part, for say Eagle CAD, then the exact pad placements and dimensions are required.

Does anyone have this information to hand?
hi,
do you mean this ?

best wishes
rudi ;-)

( see here )
taken from the resources