Help!The output is strange.

[ysw0145]

All the examples in esp-idf examples folder can not run.(In fact,I have tried many of them....).
Emmm,

[ESP_Sprite]

Are you sure your power supply (or USB lead, in case of a devboard) is good enough? Stuff like this tends to happen when the current draw of the ESP32 makes the input voltage sag too much.

[ESP_igrr]

Please check the note about XTAL frequency in the following document:
http://esp-idf.readthedocs.io/en/latest ... #configure

Most ESP32 development boards have a 40MHz crystal installed. However, some boards use a 26MHz crystal. If your board uses a 26MHz crystal, or you get garbage output from serial port after code upload, adjust the ESP32_XTAL_FREQ_SEL option in menuconfig.