Micropython EEPROM write error

[david191624]

Dear ,

I am trying to write a simple program to test my I2C EEPROM(24LC01BI_SN), i use micropython to write 0 to 100 into EEPROM address from 0 to 100,
after write success. I read back and check back the value , the value is incorrect in some address. E.g. address 10 should be contain 0x0a, but the result is 0x0b and in address 0x0c the value is "r " .... may i know that how to fix this problem?




import machine
import time

addr =0
buf[0] = 0

while buf[0]<100:
... buf[0]=buf[0]+1
... ee.writeto_mem(80, addr, buf)
... time.sleep_ms(500)
... addr=addr+1

ee.readfrom_mem(80, 10, 10)

>>>>>b'\x0b\x0c\r\x0e\x0f\x10\x11\x12\x13\x14'

ee.readfrom_mem(80, 5, 10)

>>>>>b'\x06\x07\x08\t\n\x0b\x0c\r\x0e\x0f'

[ESP_Sprite]

The code does exactly what you tell it to do. You set buf[0] and addr to 0. Then you enter the while loop and add 1 to buf[0], which is now 1, You write that to addr, which is still 0. Then you increase addr by 1, so it is now 1. The while loop restarts and you again add 1 to buff[0], which is now 2. You write that 2 to address addr, which still is 1. Etc. So essentially, you write 1,2,3,4,5,6... to the memory.

Now wrt the print: notice it says /r, not just r. This is an escape code, and if you look it up in an ascii table, you can see that it corresponds to ascii character 13.