3D Printer control

paulbearne
Posts: 3
Joined: Fri Jul 07, 2017 5:29 am

3D Printer control

Postby paulbearne » Wed Oct 25, 2017 6:58 pm

Hi i've just finished laying up a pcb to control my D-bot 3d printer based on my existing rumba board.http://esp32robots.co.uk/index.php/hard ... controller the gerbers and schematics are also on my site. and was wondering if any body has looked at porting marlin or repetier or done any firmware work for a 3d printer that i might be able to modify for my set up.

Who is online

Users browsing this forum: Baidu [Spider] and 271 guests