ESP32 S3 VGA can't display more than 5 character on the same time

[AndrewLevel100]

Code: [Select all] [Expand/Collapse]

1. #include "ESP32S3VGA.h"
2. #include <GfxWrapper.h>
3. #include <Fonts/Picopixel.h>
4. #include "EspUsbHost.h"
5.  
6. //                   r,r,r,r,r,  g,g, g, g, g, g,   b, b, b, b, b,   h,v
7. const PinConfig pins(-1,-1,-1,-1,1,  -1,-1,-1,-1,-1,2,  -1,-1,-1,-1,42,  41,40);
8.  
9. //VGA Device
10. VGA vga;
11. Mode mode = Mode::MODE_320x240x60;
12. GfxWrapper<VGA> gfx(vga, mode.hRes, mode.vRes);
13.  
14. class MyEspUsbHost : public EspUsbHost {
15.   void onKeyboardKey(uint8_t ascii, uint8_t keycode, uint8_t modifier) {
16.     if (' ' <= ascii && ascii <= '~') {
17.       gfx.print((char)ascii);
18.     } else if (ascii == '\r') {
19.       gfx.println();
20.     }
21.   };
22. };
23.  
24. MyEspUsbHost usbHost;
25.  
26. //initial setup
27. void setup()
28. {
29.   Serial.begin(115200);
30.     vga.bufferCount = 2;
31.     if(!vga.init(pins, mode, 16)) while(1) delay(1);
32.   usbHost.begin();
33.   usbHost.setHIDLocal(HID_LOCAL_Japan_Katakana);
34.     vga.start();
35.     gfx.setCursor(0, 10);
36.   vga.clear(vga.rgb(0, 0, 0));
37.     gfx.setFont(&Picopixel);
38. }
39.  
40. //the loop is done every frame
41. void loop()
42. {
43.   usbHost.task();
44.     vga.show();
45. }

GeSHi © Codebox Plus Extension

Greetings,

I'm trying to display characters to a screen with a keyboard using "ESP32S3VGA" and "EspUsbHost",
but when I write more than 5/6 characters the screen just loses signal and it just says "no signal", like it doesn't even send a signal after this character limit,
The VGA RGB are connected to GPIO 1, 2 and 42, The Hsync is 41 and the Vsync is 40.
The Keyboard is connected to the pins 20 and 19 (The USB+ and USB- of the board).
I'm using an ESP32 S3 WROOM 1 with OPI PSRAM.


Could someone figure this out?

Thanks.