Broken USB port and sketch uploading
Posted: Sun Feb 17, 2019 9:56 am
Hi, this is my first time on the forum and im very new to micro controllers. I recently purchased the following item
Wemos® TTGO WiFi + Bluetooth Battery ESP32 0.96 Inch OLED Development Tool
https://banggood.app.link/lFXGSFIunU
And have a problem where by the USB port has broken off. My question is I need to be able to program the board by using Arduino as ISP but I'm a little confused by which pins I need to connect from the Arduino as ISP (Uno R3) I'm using to the TTGO board.
I appreciate this might be a very basic question for most and I apologise.
Any help would be greatly appreciated.
Many thanks.
Wemos® TTGO WiFi + Bluetooth Battery ESP32 0.96 Inch OLED Development Tool
https://banggood.app.link/lFXGSFIunU
And have a problem where by the USB port has broken off. My question is I need to be able to program the board by using Arduino as ISP but I'm a little confused by which pins I need to connect from the Arduino as ISP (Uno R3) I'm using to the TTGO board.
I appreciate this might be a very basic question for most and I apologise.
Any help would be greatly appreciated.
Many thanks.