ESP32 Wroom-2 and WiFi issues
Posted: Sun Dec 18, 2016 6:50 pm
Hello
I have problems with using Wi-Fi. I've uploaded this sketch Wifi-scan (basic sketch from Arduino libraries)
and when i want to scan wifi i've getting error:
I was trying changing power source between FTDI breakout board and AA batteries with no luck. On power section i have 2x 100nF and 1x 47uF capacitors.
Any Ideas ?
I have problems with using Wi-Fi. I've uploaded this sketch Wifi-scan (basic sketch from Arduino libraries)
Code: Select all
#include "WiFi.h"
void setup()
{
Serial.begin(115200);
// Set WiFi to station mode and disconnect from an AP if it was previously connected
WiFi.mode(WIFI_STA);
WiFi.disconnect();
delay(100);
Serial.println("Setup done");
}
void loop()
{
Serial.println("scan start");
// WiFi.scanNetworks will return the number of networks found
int n = WiFi.scanNetworks();
Serial.println("scan done");
if (n == 0) {
Serial.println("no networks found");
} else {
Serial.print(n);
Serial.println(" networks found");
for (int i = 0; i < n; ++i) {
// Print SSID and RSSI for each network found
Serial.print(i + 1);
Serial.print(": ");
Serial.print(WiFi.SSID(i));
Serial.print(" (");
Serial.print(WiFi.RSSI(i));
Serial.print(")");
Serial.println((WiFi.encryptionType(i) == WIFI_AUTH_OPEN)?" ":"*");
delay(10);
}
}
Serial.println("");
// Wait a bit before scanning again
delay(5000);
}
Any Ideas ?