What should be nominal deep sleep current consumption with touch pin enabled
Posted: Wed Jul 26, 2023 10:20 pm
Hi,
I am using ESP32-S3-WROOM-1 module on a minimal custom circuit board with 3v direct connection to a lithium battery.
With one touch pin enabled, the deep sleep measured is around 100uA. Is that normal? What else should I do minimize power consumption further?
Basically, I want it to monitor touch pin while in deep sleep with lowest possible power consumption notwithstanding clock speed etc.
Thanks,
Jay
I am using ESP32-S3-WROOM-1 module on a minimal custom circuit board with 3v direct connection to a lithium battery.
With one touch pin enabled, the deep sleep measured is around 100uA. Is that normal? What else should I do minimize power consumption further?
Basically, I want it to monitor touch pin while in deep sleep with lowest possible power consumption notwithstanding clock speed etc.
Thanks,
Jay