ESP32 boards(esp32s2, esp32c3, esp32s3) doesn't reset after upload
Posted: Thu Nov 24, 2022 11:30 am
Board: ESP32 Boards
Device Description: ESP32-C3-DevKitC, ESP32-S3-DevKitC, Deneyap Mini and Deneyap Kart G
Hardware Configuration: Native USB port plugged into computer, serial convert USB port not plugged in
Version: v2.0.4, v2.0.5
IDE Name: Arduino IDE 2.0.2, Arduino IDE 2.0.1, Arduino IDE 2.0.0, Arduino IDE 1.8.19
Operating System: Windows 10
Flash frequency: 80MHz
PSRAM enabled: enable
Upload speed: 921600
Description: I reset my ESP boards(without usb to uart), then I can't upload. I boot manually but then reset it again so I always boot manually.
Device Description: ESP32-C3-DevKitC, ESP32-S3-DevKitC, Deneyap Mini and Deneyap Kart G
Hardware Configuration: Native USB port plugged into computer, serial convert USB port not plugged in
Version: v2.0.4, v2.0.5
IDE Name: Arduino IDE 2.0.2, Arduino IDE 2.0.1, Arduino IDE 2.0.0, Arduino IDE 1.8.19
Operating System: Windows 10
Flash frequency: 80MHz
PSRAM enabled: enable
Upload speed: 921600
Description: I reset my ESP boards(without usb to uart), then I can't upload. I boot manually but then reset it again so I always boot manually.