About ESP32-WROOM-32U About Wifi communication failure to Arduino
Posted: Tue Mar 22, 2022 9:29 am
detail
The program is created with Arduino and
I'm writing.
Transmission format MQTT
am.
The following will happen.
Operate about 30 units with the same board and the same program,
I wrote the program and it worked fine. after that
Keep working,
About 20 hours later
Only one
Wifi does not connect.
And when you open the serial
The data rst: 0x3 (SW_RESET), boot: 0x13 (SPI_FAST_FLASH_BOOT) is output as eternity.
As per the attached file.
Only 1 out of 30
Wifi not connected
It became like the following URL.
URL https://www.dropbox.com/s/msrdrewndiqe9 ... 2.png?dl=0
Is there anything you can think of?
please tell me.
The program is created with Arduino and
I'm writing.
Transmission format MQTT
am.
The following will happen.
Operate about 30 units with the same board and the same program,
I wrote the program and it worked fine. after that
Keep working,
About 20 hours later
Only one
Wifi does not connect.
And when you open the serial
The data rst: 0x3 (SW_RESET), boot: 0x13 (SPI_FAST_FLASH_BOOT) is output as eternity.
As per the attached file.
Only 1 out of 30
Wifi not connected
It became like the following URL.
URL https://www.dropbox.com/s/msrdrewndiqe9 ... 2.png?dl=0
Is there anything you can think of?
please tell me.