My own pcb with Arduino IDE
Posted: Mon Sep 02, 2019 10:44 pm
by Hiroci
If I design my own board with the esp32, how can I program it with the Arduino IDE
Re: My own pcb with Arduino IDE
Posted: Tue Sep 03, 2019 8:11 am
by Agree007
Assuming you pcb have the required usb port, then connect it to you pc with Arduino ide (with esp32 support setup) select the esp32 module closest to your own module, that will work unless you board are very special.
Re: My own pcb with Arduino IDE
Posted: Tue Sep 03, 2019 1:04 pm
by lbernstone
If you don't intend to have a USB connector, put a 6 pin header on the board with 3V3/En/Gnd/Rx/Tx/IO0 and use an external CP2102 USB->UART adapter like
https://www.aliexpress.com/item/2035365243.html