Cant find Serial Port after download
Posted: Wed Aug 14, 2019 12:55 pm
Hello
I am using Arduino IDE on Visual Studio 2019 with Visual Micro ( but same in standard IDE). I have some code which was working ok on breadboard with an old ESPdevkit I had. Ive now made some PCB and bought some new Devkit C modules. After programming the unit worked as expected, but having unplugged it, it now sees port in list, but will not connect, and gives a 'Port not Available' message.
I have checked that GPIO 0 and EN are both normally high. Also checked that GPIO1212 is LOW. I also cannot see any activity on these lines when selecting port.
I still suspect DTR/CTS but not sure how I can change them. Lots of posts say set terminal to Disable DTR/RTS but no one says how!!
Have I just been unlucky, and Ive got a dead board, or am I doing/not doing something obvious.
Help please
Steve
I am using Arduino IDE on Visual Studio 2019 with Visual Micro ( but same in standard IDE). I have some code which was working ok on breadboard with an old ESPdevkit I had. Ive now made some PCB and bought some new Devkit C modules. After programming the unit worked as expected, but having unplugged it, it now sees port in list, but will not connect, and gives a 'Port not Available' message.
I have checked that GPIO 0 and EN are both normally high. Also checked that GPIO1212 is LOW. I also cannot see any activity on these lines when selecting port.
I still suspect DTR/CTS but not sure how I can change them. Lots of posts say set terminal to Disable DTR/RTS but no one says how!!
Have I just been unlucky, and Ive got a dead board, or am I doing/not doing something obvious.
Help please
Steve