I started tinkering with ESP few days earlier. I tried following few example codes and was able to got the camera feed up and running. But for a project, I need to access an analog input as well along with the camera feed.
Is there any concrete example to refer to regarding ESP32 CAM module? I found several for generic ESP 32. I have tried few references from here and there but no luck. Moreover looks like not every adc supporting pin is available on this board.
Few stuffs that I have tried -
Code: Select all
pinMode(mPin, INPUT);
adcAttachPin(mPin);
analogReadResolution(11);
analogSetAttenuation(ADC_11db);
analogRead(mPin); /* << Gives a fixed output of 40XX */
Code: Select all
int read_raw;
adc2_config_channel_atten( ADC2_CHANNEL_7, ADC_ATTEN_0db );
esp_err_t r = adc2_get_raw( ADC2_CHANNEL_7, ADC_WIDTH_12Bit, &read_raw);
if ( r == ESP_OK ) {
printf("%d\n", read_raw );
} else if ( r == ESP_ERR_TIMEOUT ) {
printf("ADC2 used by Wi-Fi.\n");
} /* << Compiles successfully, but crashes while flashing. */
Board in use
Something like this one -
https://www.banggood.in/Geekcreit-ESP32 ... rehouse=CN
Has anyone faced or have similar experience in fetching analog value along with wifi cam stream?