What does spi_device_interface_config_t.mode mean
Posted: Sun Jun 03, 2018 9:07 am
Hi,
I am wondering if there are any description about the .mode field in spi_device_interface_config_t structure?
Currently I can only find a simple comment line like "SPI mode (0-3) ", where can one find descriptions about the meaning for each value of "0, 1, 2, 3"?
I am wondering if the mode here means half-duplex or full-duplex, or anything else?
Below is what I can find from spi_master.c source code:
In my case, I am using 4 wire nCS, MISO, MOSI, SCLK to access a ADC module. I can read a single register byte using either mode 0 or 3.
Now I want read a batch of bytes from a starting register address, assuming their addresses are continuous. I am unsure if mode is related to this continuous read or not.
Regards,
peterlspot
I am wondering if there are any description about the .mode field in spi_device_interface_config_t structure?
Currently I can only find a simple comment line like "SPI mode (0-3) ", where can one find descriptions about the meaning for each value of "0, 1, 2, 3"?
I am wondering if the mode here means half-duplex or full-duplex, or anything else?
Below is what I can find from spi_master.c source code:
Code: Select all
if (dev->cfg.mode==0) {
host->hw->pin.ck_idle_edge=0;
host->hw->user.ck_out_edge=0;
host->hw->ctrl2.miso_delay_mode=nodelay?0:2;
} else if (dev->cfg.mode==1) {
host->hw->pin.ck_idle_edge=0;
host->hw->user.ck_out_edge=1;
host->hw->ctrl2.miso_delay_mode=nodelay?0:1;
} else if (dev->cfg.mode==2) {
host->hw->pin.ck_idle_edge=1;
host->hw->user.ck_out_edge=1;
host->hw->ctrl2.miso_delay_mode=nodelay?0:1;
} else if (dev->cfg.mode==3) {
host->hw->pin.ck_idle_edge=1;
host->hw->user.ck_out_edge=0;
host->hw->ctrl2.miso_delay_mode=nodelay?0:2;
}
In my case, I am using 4 wire nCS, MISO, MOSI, SCLK to access a ADC module. I can read a single register byte using either mode 0 or 3.
Now I want read a batch of bytes from a starting register address, assuming their addresses are continuous. I am unsure if mode is related to this continuous read or not.
Regards,
peterlspot